Interior Plaster

Surface Preparation

All surfaces must be cured, clean, sound, dry and free of all dirt, dust, efflorescence, wax, oil, grease, chalk and any other contamination that would interfere with new coating adhesion. New plaster must cure for a minimum of 30 days at 72°F (22°C) prior to coating application. Sand smooth and dust. Fill cracks with spackling compound, allow to dry and sand smooth. Remove sanding dust. Performance will be directly related to the degree of surface preparation.

Recommended Products

Primers: OmniPrep Universal Interior/Exterior Primer

Finishes: Permacryl Interior Acrylic Latex Enamel
  Vantage Plus Interior Latex
  Assure Interior Latex Enamel
  Zero Plus Interior Zero VOC* Latex

The products above are commonly recommended for plaster. Other Diamond Vogel products, including our High Performance Coatings, may be better suited for your project. Please contact your Diamond Vogel representative for personalized service.

*Zero Plus is designated zero VOC (volatile organic compounds) based on EPA Method 24. All zero VOC paints emit chemicals. This paint emits chemicals during and for approximately two weeks after painting but at much lower levels than conventional latex paints. Sensitive groups should minimize exposure during painting and for 24 hours after. “Zero VOC” does not mean “asthma/allergy friendly.”