All new wood surfaces must be cured, clean, sound, dry and free of all dirt, dust, efflorescence, wax, oil, grease, chalk and any other contamination that would interfere with new coating adhesion. Sand smooth. Patch nail holes and any imperfections with wood filler or putty and sand smooth. Remove sanding dust. On previously painted surfaces, be sure the surface is free of all contaminants and dull all glossy surfaces by sanding. Performance will be directly related to the degree of surface preparation.
|Primers:||Mill Max Latex Enamel Undercoat|
|Finishes:||SureFlo Interior/Exterior Acrylic Latex Enamel|
|Permacryl Interior Acrylic Latex Enamel|
|Vantage Plus Interior Latex|
|Zero Plus Interior Zero VOC* Latex|
|Spray-Only Finish:||Super Quick 30 Acrylic Latex Spray Enamel|
The products above are commonly recommended for wood trim and millwork. Other Diamond Vogel products may be better suited for your project. Please contact your Diamond Vogel representative for personalized service.
*Zero Plus is designated zero VOC (volatile organic compounds) based on EPA Method 24. All zero VOC paints emit chemicals. This paint emits chemicals during and for approximately two weeks after painting but at much lower levels than conventional latex paints. Sensitive groups should minimize exposure during painting and for 24 hours after. “Zero VOC” does not mean “asthma/allergy friendly.”