All surfaces must be cured, clean, sound, dry and free of all dirt, dust, efflorescence, wax, oil, grease, chalk and any other contamination that would interfere with new coating adhesion. Consult our ferrous metal surface preparation recommendations or contact us for assistance. Performance will be directly related to the degree of surface preparation.
|Primers:||Vers-Acryl 300 Acrylic DTM Primer|
|CoteAll Multi-Purpose Alkyd Primer|
|Primer/Finish:||Vers-Acryl 303 Acrylic DTM Primer/Finish|
The products above are commonly recommended for ferrous metal. Other Diamond Vogel products, including zinc-rich primers, epoxies and polyurethanes from our High Performance Coatings, may be better suited for your project. Please contact your Diamond Vogel representative for personalized service.
*Zero Plus is designated zero VOC (volatile organic compounds) based on EPA Method 24. All zero VOC paints emit chemicals. This paint emits chemicals during and for approximately two weeks after painting but at much lower levels than conventional latex paints. Sensitive groups should minimize exposure during painting and for 24 hours after. “Zero VOC” does not mean “asthma/allergy friendly.”